2.3. 硬體支援

FreeBSD 可以在很多種的 PC 匯流排正常執行,諸如 ISA、VLB、EISA 以及PCI,從 386SX 等級到 Pentium 都可以運作 (但不建議在 386 等級系統)。 支援一般的 IDE、ESDI 或 ESDI 驅動設定,各種的 SCSI 控制器、網路、 以及串列卡也有支援。FreeBSD 也支援 IBM 的 microchannel (MCA) 匯流排。

為了要執行 FreeBSD,建議最少需要 8MB RAM。 Sixteen megabytes is the preferred amount of RAM as you may have some trouble with anything less than sixteen depending on your hardware.

接下來的是一長串已知可在 FreeBSD 下運作的磁碟控制器和乙太網路卡。 其他設定可能運作的很好,但是我們並沒有找到其他這類的指示。

2.3.1. 磁碟控制器

With all supported SCSI controllers, full support is provided for SCSI-I and SCSI-II peripherals, including hard disks, optical disks, tape drives (including DAT and 8mm Exabyte), medium changers, processor target devices, and CDROM drives. WORM devices that support CDROM commands are supported for read-only access by the CDROM driver. WORM/CD-R/CD-RW writing support is provided by cdrecord, which is in the ports tree.

下面的 CD-ROM 典型系統在此時被支援:

The following drivers were supported under the old SCSI subsystem, but are NOT YET supported under the new CAM SCSI subsystem:

Unmaintained drivers, which might or might not work for your hardware:

2.3.2. 乙太網路卡

2.3.3. USB Peripherals

A wide range of USB peripherals are supported. Owing to the generic nature of most USB devices, with some exceptions any device of a given class will be supported even if not explicitly listed here.

Motherboard chipsets:

PCI plug-in USB host controllers

Specific USB devices reported to be working:

2.3.4. ISDN (European DSS1 [Q.921/Q.931] protocol)

2.3.5. Sound Devices

The following soundcards or codecs are supported (devices marked 'experimental' are only supported in FreeBSD-CURRENT and might work only unstably):

2.3.6. 各種裝置